Lock Out Tag Out Isolation Equipment

Lock out tag out step 3 isolation the two major steps involved with the actual lock and tag out are steps 3 and 4.

Lock out tag out isolation equipment.

A lockout device is a mechanical means of locking that uses an individually keyed lock to secure an energy isolating device in a position that prevents energization of a machine equipment or a process lockout is one way to control hazardous energy. The osha standard for the control of hazardous energy lockout tagout 29 cfr 1910 147 for general industry outlines measures for controlling different types of hazardous energy. During this step the authorized employee will attach lockout and or tagout devices to each energy isolating device. Some equipment is fed only by a single switch while other equipment may include capacitors or backup batteries that must be discharged or disconnected to ensure the equipment does not receive power.

Lockout tagout loto is a safety method enforced by putting the appropriate lockout or tagout devices to energy isolating devices in accordance with an established procedure ensuring that the energy isolating device and the equipment being controlled cannot be operated until the lockout device is removed. Why use lockout tagout. It s fair to say that this entire six step process takes its name from this step. With the machine or equipment isolated from its energy source the next step of lockout tagout is to actually lock and tag out the machine.

Most have information on why the lockout is required time the lockout tag and lock was installed and the name of the authorized person who attached the tag and lock to the system. When a tagout device is used on an energy isolating device which is capable of being locked out the tagout device shall be attached at the same location that the lockout device would have been attached and the employer shall demonstrate that the tagout program will provide a level of safety equivalent to that obtained by using a lockout program. Lockout tagout refers to the safety procedure used in industry and research settings to insure that dangerous machines have been properly shut down and are incapable of being started up again prior to the completion of maintenance or servicing work. Step 3 is the isolation of the machine or equipment which involves disconnecting and deactivating all of the machine equipment energy sources.

Osha s lockout tagout fact sheet describes the practices and procedures necessary to disable machinery or equipment to prevent hazardous energy release. It s reasonable to say that this entire six step process gets its name from this step.